Register Dry Tubes

Registers new dry tubes to Chempion.

In the upper table you fill the information of the new tubes, with an optional location.

In the bottom table you will see the location of the tubes, and an indication weather it is a new location or not, if the location is new, you will also need to set the location type and parent location.

Here is an example snapshot:

Register Liquid Tubes

Registers new Liquid tubes to Chempion.

Same behavior as "Register Dry Tubes" only here you will also need to fill solvent name and percent with an optional 2D barcode.

Here is an example snapshot:

Dissolve Single Tubes

Dissolves single tube/s to destination tube/s.

Each row in the upper table needs to get the source tube and new destination tube.

New/existing location will be shown in the bottom table.

Here is an example snapshot:

Dissolve and Split Tubes

Dissolves tube/s and splits to destination tube/s.

Each row in the upper table needs to get the source tube and new destination tube prefix, it will create several destination tubes with this prefix according "Splits" value (number of splits), .

New/existing location will be shown in the bottom table.

Here is an example snapshot:

Split Liquid Tubes

Dissolves tube/s and splits to destination tube/s.

Each row in the upper table needs to get the source tube and new destination tube prefix, it will create several destination tubes with this prefix according "Splits number" value (number of splits), .

New/existing location will be shown in the bottom table.

Transfer from Tubes to Plates

Transfers from tubes to plate/s.

Each row in the upper table represents a transfer from an existing tube to an exsiting/new plate.

In the bottom table you will see all the relevant existing/new plate/s, if the plate is new, you will need to set the location.

Here is an example snapshot:

Update Compounds

Updates compounds in tube/s.

You will only need to fill the tube name, and the fields you want to update.

Here is an example snapshot - you can see that we chage the supplier MW in tube1 to 3.5 and the volume in tube2 to 10:

Deletes existing tubes.

You just need to fill the tube name in each row.

Here is an example snapashot: